top of page

Glossy dispersion paint for exterior and interior use. Elastic with up to 50% stretch. Resistant to abrasion. Super washable.

Type of material:

For the formation of silky-glossy coatings resistant to abrasion in the external and internal sector. On surfaces made of concrete, plaster and plaster, as well as lightweight building boards. Ideal for painting on fiberglass, coarse fiber and textured wallpaper. When applied in 3 coats, it closes cracks up to 1mm, not allowing them to come out.



Gloss level:

silky glossy.


Water, synthetic acrylic dispersion, titanium dioxide, fillers, additives, preservative.


Approximately 1.3 g / cm3.


By brush, roller, airless spray (nozzle 0.026 to 0.031 inches or 0.66 to 0.79 mm; pressure 6-8 bar, spray angle 40 - 80 °).


Resistant to repeated abrasion and washing, durable. Does not contain solvents. Convenient in processing, has a high hiding power, is capable of good adhesion and adhesion. Very economical. Forms durable silky-glossy surfaces, lightfast. Forms a coating that can stretch up to 50%.

Substrate preparation:

The paint can be applied to all solid substrates, they must be clean, dry and sound. Old glue whitewash must be completely removed. Prime fresh cement-based plaster and repaired areas. Treat intensively moisture-absorbing and chalky surfaces with Kaizer Tiefgrund LF primer, Kaizer Putzgrundharter 1: 4 gypsum plaster. Observe the relevant processing rules.

Painting procedure:

1st (priming) coat: thin the paint with a maximum of 10% water.

2nd (final) coating: do not thin if possible.

When painting, make sure that the material is applied evenly.


Any water-dispersive color scheme.

Cleaning tools:

Rinse with water immediately after use.


In a cool and dry place, protected from frost. Store opened and incompletely used containers tightly closed. Shelf life in the original packaging of the manufacturer is 12 months.


1kg, 5kg, 10kg, 20kg


130 g of paint is sufficient for approx. 1 m2 in one coat on a smooth surface; variations may occur depending on the quality of the substrate. On rough surfaces, fiberglass, respectively, more, approximately 180-200g / m2.

The most reliable method of accurately establishing the flow rate is a test painting.

Drying time:

At room temperature + 20 ° C, re-coating is possible on the same day. At cool temperatures, the drying time increases accordingly.

Processing temperature:

+ 5 ° C minimum for substrate and atmosphere during application and during drying.


According to local regulations.


Keep out of reach of children.

In case of contact with eyes, flush with plenty of water.

Do not empty into drains.

Special facade paint. "Plastik farbe"

1 Kilogram
    Логотип с белым фоном.png

    Наш адрес: Алматы, ул. Спасская, 68. Лакокрасочный завод Kaizer.  

    • 8 (701) 032-83-15

    bottom of page